by Editor | Jun 30, 2020 | News
A complete automatic control system was designed, manufactured and installed to monitor and maintain environmental conditions within the pool area. The control system manages the pool water temperature, pool air temperature, changing area temperatures, pumping and...
by Editor | Jun 30, 2020 | News
Smith & Cork completed the design, manufacture and installation of this 2500A switchboard. The switchboard included a section for G99 controls. Each of the ACB’s were motorised to allow fully automatic control and island mode operation of 5 standby generators. We...
by Editor | Jun 30, 2020 | News
This project currently holds the record for the fastest turnaround ever! Smith & Cork were approached by a leading national standby power provider to assist with the electrical installation and switchboard manufacture for 2 x 250kW gas engines. A design was...
by Editor | May 30, 2020 | News
Smith & Cork Electrical were contracted to undertake the complete design, manufacture and installation of an LV distribution network for a major UK anaerobic digestion plant. The main 3200A switchboard measured over 10m long, manufactured in sections and then...
by Editor | May 5, 2020 | News
A stainless steel floor standing control panel for a wastewater plant. Smith & Cork Electrical are contracted to carry out the electrical installation also.
by Editor | May 5, 2020 | News
The project was undertaken to replace the ageing gas fired heating boilers and circulating pumps. The old control system was also replaced. A new plantroom was built to house the new boilers and control panel, whilst the pump sets within the existing plantroom were to...
